Signs of a Blown Head Gasket: Diesel Trucks and Engines

Is it my head gasket?

Signs of a blown head gasket: diesel symptoms and what to check first

The first signs of a blown head gasket on a diesel are usually coolant you keep adding with no leak to show for it, and a cooling system that pressurizes: coolant pushed out of the overflow, or a hard upper hose soon after a cold start. White smoke after warm up, bubbles in the coolant tank and running hot under load often follow, and a block test can confirm it for about $10 in fluid.

We are the experts in cooling systems. We find what caused the failure, not only fix the gasket.

Why a diesel shows it differently

A diesel runs higher compression and lower operating temperatures than a gas engine. When the head gasket is breached, that compression pushes combustion gas into the cooling system hard, so the pressure often shows up first.

A diesel is often how somebody earns a living. Thermalweld has repaired tractor trailers, dump trucks, diesel pusher RVs, farm tractors and forklifts. Among pickups, the GM 6.6 Duramax and the Ram Turbo Cummins are known for head gasket trouble.

Seven signs of a blown head gasket on a diesel

  1. You keep adding coolant, and there is no puddle. A blown head gasket always loses coolant, most often out the exhaust.
  2. The cooling system pressurizes. Coolant gets pushed out of the overflow or degas bottle, or the upper hose goes hard soon after a cold start, before the engine is hot.
  3. Bubbles in the coolant tank with the engine running: combustion gas pushed in by the pistons.
  4. White smoke that keeps coming after the engine is warm. That is steam, and it smells sweet. White smoke on a cold start can also be fuel that has not burned yet; it smells like diesel and clears as the engine warms.
  5. Running hot under load, towing, hauling or on a long grade. Combustion gas can trap an air pocket around the thermostat so it never opens, and coolant lost as steam drops the level.
  6. Coolant in the oil. A milky coffee look under the oil cap, or an oil level that climbs on the dipstick. It is the rarer sign, so clean oil does not clear you.
  7. Rough running, a miss or lost power. Coolant in a cylinder does not burn, and a check engine light can come on.

More: blown head gasket symptoms and white smoke and losing coolant.

Rule out the lookalikes

  • An EGR cooler leak can send coolant out the exhaust as white smoke.
  • An oil cooler failure can put oil in the coolant or coolant in the oil.
  • A leaking radiator, a split hose or a weak cap lets coolant out with no head gasket involved.

Call us with what you see, and we help you sort it out before you spend a dollar.

How to test a diesel for a blown head gasket

  • Block test. Most auto parts stores lend the tester, and the fluid costs about $10. On a diesel the blue fluid usually turns green when combustion gas is in the coolant. A shop charges around $35 to $50. Dave Whitmer, our field technician, shows how: How to do a block test.
  • Cooling system pressure test. Pressure that drops with no drips points to a leak inside the engine.
  • Compression test at a shop, to find the cylinder.

If the oil cap is milky, read the dipstick. Five inches or more over the full mark can point to a cracked block, so call us first. More on how to tell if your head gasket is blown.

What usually causes it

  • A cooling system part failed first: a stuck thermostat, a weak water pump, a clogged radiator, a fan that does not come on, or a cap that no longer holds pressure.
  • More boost or power than the engine was built for, from tuning.
  • Age and hard work.

Seal the gasket and leave the failed part in the truck, and the new seal usually goes the same way.

Can it be fixed without pulling the heads?

It can be, if the engine still starts and runs. Thermalweld seals the breach from inside the cooling system while the engine runs.

  1. Confirm it with a block test or a pressure test.
  2. Fix the cause.
  3. Flush the antifreeze out with plain water, heater core included. Thermalweld does not mix with antifreeze.
  4. Treat it the diesel way: pour it into the surge tank or radiator, idle and cool down in rounds, then drive a short way in a lower gear, exactly as the diesel steps in the easy repair instructions say. Never open the cap until the engine has cooled completely.

Diesel kits are sized to the cooling system: under 10 gallons, 10 to 20, and over 20. See head gasket repair cost. Call us before you start, and we walk you through it.

When sealing it is not the answer

  • It will not start, or will not turn over. The repair works while the engine runs. If it will not turn over, it may be hydrolocked; do not keep cranking it.
  • Coolant pours out of the tail pipe. Some engines are too far gone: Head gaskets that are too far gone.

Until it is fixed, drive it as little as you can; every mile makes the breach bigger.

Already tried a sealer that did not work?

Where other products failed, we help you fix it. Before anything else goes in, call us.

Free unlimited tech support from the people who make it

Call (844) 796 7968 at any step. You talk to the people who make Thermalweld, as often as you need, free. Nobody else in the industry offers that. Thermalweld is BBB accredited and A+ rated.

We are saving livelihoods one blown head gasket at a time.

For diesel mechanics and fleet shops

A diesel waiting on a head job is a crew not working. Confirm it, fix the cause, seal it with the heads on, and call us whenever the job gets tough. Unheard of in the industry. Nobody else comes close.

Mechanics: your first bottle is free. So is the unlimited tech support. thermalweld.com/technicians

Need a mobile mechanic? We find one for you.

Call (844) 796 7968 and tell us where the car is. At our cost, we call mobile mechanics in your area, qualify a well reviewed one for your job, and back them with free, unlimited tech support from start to finish. We know of no other head gasket brand that does this. How we find your mechanic

Quick answers

What are the first signs of a blown head gasket on a diesel?

Usually coolant loss with no leak you can find, and a cooling system that pressurizes, pushing coolant out of the overflow.

Is white smoke from a diesel always a blown head gasket?

No. White smoke on a cold start can be unburned fuel that clears as the engine warms. Steam from coolant smells sweet and keeps coming after warm up, and the coolant level drops.

How do you test for a blown head gasket on a diesel?

Start with a block test: the fluid costs about $10, and on a diesel it usually turns green when combustion gas is in the coolant. A shop pressure or compression test adds detail.

Is it a blown head gasket or a cracked head?

They can show the same signs, and a block test can turn for either. Call (844) 796 7968 with your result, and we help you work out which.

Does head gasket sealer work on a diesel?

It can, on the right engine, when it still starts and runs and the cause is fixed. Thermalweld diesel kits are sized to the cooling system.

More answers

This page is a guide, not a diagnosis. Call (844) 796 7968 with your engine, mileage and symptoms.