Losing Coolant With No Leak? Where It Goes and How to Tell

Is it my head gasket?

Losing coolant with no leak: where is it going?

If you keep adding coolant, or antifreeze, and there is never a puddle, it is usually leaving where you cannot see it, most often out the tail pipe as steam through a blown head gasket. The other usual places are the heater core, the pressure cap, and a small leak that dries on hot parts before it can drip.

We are the experts in cooling systems. We find what caused the failure, not only fix the gasket.

First, put a number on it

  • Check the level cold, before the first drive of the day. Never open the cap until the engine has cooled completely.
  • Fill to the full mark, not over. A tank filled past it can push the extra out of the overflow as it heats up.
  • Note how much you add per 100 miles. Under a quart is not a major breach. More means a bigger one, and a head gasket breach grows every mile.

Where coolant goes when there is no puddle

Into the engine, and out the tail pipe

  • A blown head gasket. Coolant gets into a cylinder, flashes to steam and leaves through the exhaust, often as a fine mist you cannot see at 60 mph. A blown head gasket always loses coolant. More on white smoke and losing coolant with no leak.
  • A cracked head or block, which shows the same signs.
  • A leaking intake gasket, on engines that run coolant through the intake.
  • A leaking turbo seal, on turbocharged engines.
  • A cracked EGR cooler on a diesel. Coolant gets into the hot exhaust and leaves as vapor.

Into the car

  • A leaking heater core, the small radiator behind the dash. Look for a sweet smell inside the car, windows that fog up and will not clear, or damp carpet on the passenger side.

Out of the engine, with nothing on the ground

  • The pressure cap. A worn seal or a weak spring lets coolant out as vapor or into the overflow, and leaves no puddle.
  • A small leak on a hot engine. Some leaks open only when the system is warm and under pressure, and the coolant dries on hot parts before it can drip. Look for dried, crusty or white streaks on the hoses, the radiator, the thermostat housing and the weep hole on the water pump.

Not in the oil, not overheating: can it still be the head gasket?

Yes.

  • Clean oil does not clear you. In Dave Whitmer’s field experience, a milky oil cap shows up in at most 1 in 10 blown head gaskets. The coolant usually leaves through the tail pipe.
  • A normal gauge does not clear you either. Overheating is usually what blows a head gasket, not what follows it. A small breach can lose coolant while the gauge stays normal.
  • If it is overheating too, stop driving it. Low coolant overheats any engine.

Find it with three tests

  1. Block test, about $10. Most auto parts stores lend the tester, and you buy the fluid. The blue fluid turns yellow when combustion gas is in the coolant, which is what a breached head gasket lets through. A shop charges around $35 to $50. Dave shows how: How to do a block test.
  2. Cooling system pressure test. On a cold engine, to the cap’s rated pressure and never higher. Pressure that drops with no drips anywhere points to a leak inside the engine. UV dye can find a small outside leak.
  3. Test the cap and check the cabin. A cap tester shows a worn seal or a weak spring. Then feel the passenger floor for damp carpet.

Holds pressure, but still losing coolant? A cold pressure test can miss a head gasket that leaks only when the engine runs; the block test, done running, catches it. More on how to tell if your head gasket is blown.

Can it be fixed without pulling the head?

It can be, when it is the head gasket and the engine still starts and runs. Thermalweld seals the breach from inside the cooling system while the engine runs.

  1. Confirm it with a block test.
  2. Fix the cause. Most head gaskets blow because a cooling system part failed first: a stuck thermostat, a weak water pump, a clogged radiator or a fan that does not come on.
  3. Flush the antifreeze out with plain water, heater core included. Thermalweld does not mix with antifreeze.
  4. Treat it exactly as the easy repair instructions say, then bring the engine up to operating temperature at least four times over the next three days.

Kits by engine: head gasket repair cost. Call us before you start.

When sealing it is not the answer

  • A leaking heater core, cap or hose: call us and we help you find which one failed.
  • An intake gasket or a diesel EGR cooler: call us before anything goes in.
  • It will not start, or will not turn over. The repair works while the engine runs. If it will not turn over, do not keep cranking it.

Already tried a sealer that did not work?

Where other products failed, we help you fix it. Before anything else goes in, call us.

Free unlimited tech support from the people who make it

Call (844) 796 7968 at any step. You talk to the people who make Thermalweld, as often as you need, free. Nobody else in the industry offers that. Thermalweld is BBB accredited and A+ rated.

We are saving livelihoods one blown head gasket at a time.

For mechanics

Coolant loss over a dry driveway is a cooling system job before it is a gasket job. Pressure test it cold, block test it running, and check the cap and heater core before you quote. On a diesel, a positive block test can mean the EGR cooler as well as the head gasket. When it is the head gasket, fix the cause, seal it with the head on, and call us whenever the job gets tough. Unheard of in the industry. Nobody else comes close.

Mechanics: your first bottle is free. So is the unlimited tech support. thermalweld.com/technicians

Need a mobile mechanic? We find one for you.

Call (844) 796 7968 and tell us where the car is. At our cost, we call mobile mechanics in your area, qualify a well reviewed one for your job, and back them with free, unlimited tech support from start to finish. We know of no other head gasket brand that does this. How we find your mechanic

Quick answers

Why am I losing coolant but there is no leak?

It is usually leaving where you cannot see it: out the tail pipe as steam through a blown head gasket, into the cabin through the heater core, or out the pressure cap as vapor. A block test and a pressure test tell you which.

Where does coolant go if it is not leaking?

Most often out the tail pipe, as a mist you cannot see at speed. It can also go into the oil, or dry on hot parts before it drips.

Can you lose coolant with no leak and no overheating?

Yes. A small head gasket breach or a weak cap can lose coolant while the gauge stays normal. Measure how much you add per 100 miles; under a quart is not a major breach.

Is it the head gasket if the coolant is not in the oil?

It can be. In Dave Whitmer’s field experience, coolant shows up in the oil in at most 1 in 10 blown head gaskets. A block test settles it for about $10.

Can I keep driving while it is losing coolant?

As little as you can. Check the level cold before every trip, and if the gauge climbs, pull over and shut it off. Every mile makes a head gasket breach bigger.

More answers

This page is a guide, not a diagnosis. Call (844) 796 7968 with your engine, mileage and symptoms.